Program steps and cycles | Turning cycles
8
Tool path description:
The tool initially moves to the
Start Point
, offset by the
Clearance
distance
The roughing passes are optional. If the roughing feed rate is 0,
the rough passes are skipped.
The amount of material machined on each rough pass is
determined by the system and will not exceed the specified
Pass
value
The
Contour
is machined at the feed rate programmed in the
step. When the tool plunges directly into the material, the full
cut override is applied to the feed.
If a
Finish
allowance is specified, the programmed amounts are
left on the X and Z surfaces to be removed on the finish pass.
The tool returns to the
Starting point
after completing the
rough passes
The
Finish
pass is optional. If finish
Feed
is 0, the
Finish
pass is
skipped.
The direction of the
Finish
pass matches the direction of the
programmed contour
The tool returns to the
Starting point
after the
Finish
pass
completes
If the approach move interferes with the part or
fixturing, it may be necessary to program a
Position
step to position the tool on the proper side of the part or
fixture prior to the
Contour
path.
128
ACU-RITE | TURNPWR | User's Manual | 08/2020
Summary of Contents for TURNPWR
