Programming | G-code programs
7.2
G-code programs
G-code editing capabilities
G-code programs have basic editing capabilities. The value of an
existing g-code address can be changed.
There are no soft keys available for editing, all navigation is done
using the
Arrow
keys. Use
Up Arrow
and
Down Arrow
keys to
move the cursor to the line that needs to be edited and press the
ENTER
key to edit the line.
Use the
Left Arrow
and
Right Arrow
keys to move from address
value to address value within the line. Enter the new value for an
address. The
Up Arrow
and
Down Arrow
keys do not function in
this mode.
Only the value of an address when highlighted can be changed.
The
CANCEL
key will cancel any edits made. The
ENTER
key and
the
Left Arrow
or
Right Arrow
key accepts changes made to an
address, and then moves to the next address. The
USE
key accepts
the changes to the line and allows use of
Up Arrow
and
Down
Arrow
keys.
The values of the following addresses can be edited: D, F, I, J, K, L,
M, N, O, P, R, S, T, U, W, X, Y, and Z. For additional information, see
"G-code and M-Code definitions", Page 108.
A highlighted line can be removed by pressing the
CLEAR
key.
The control will calculate the block form of the G-code program.
The values for the block form can be viewed using the
Block Form
soft key. The block form can be edited and even inserted into the
program by using the soft key
Insert G120
. Once inserted in the
program (G120), the block form in the program is used. Remove the
line containing the G120 to revert back to the calculated block form.
7
ACU-RITE | TURNPWR | User's Manual | 08/2020
105
Summary of Contents for TURNPWR
