67
7. MAINTENANCE:
Carburetor adjustment:
The carburetor is a vital part of the engine. Adjusting should be left to a dealer with
the professional knowledge, specialized date, and equipment to do so properly.
Clean fuel filter:
Engine oil replacement:
1.
Unscrew but unloosen the screw 1
and take off the left exterior cover 2.
2.
Drain the fuel in the fuel tank. Hold
the tube clip 3 toward downward and
pull out the fuel tube 4 which connect
on the fuel tank, then disassemble fuel
filter.
3.
Put the fuel filter 5 into
non
-combustible or higher flash point
solvent and clean it.
4.
Assemble fuel filter to the main jet 6
on the
f
uel tank, then as
s
emble fuel
tube to main jet on the fuel tank and
install tube clip.
Avoid draining the engine oil
immediately after stopping the engine.
The oil is hot and should be handled
with care to avoid burns.
1.
Place the generator on a level
surface and warm up the engine
for several minutes.
2.
Unscrew but unloosen the screw 1
and t
ake off the sight glass of engine
oil 2.
3.
L
ift and incline the machine; take off
the end cap 3 at the
bottom plate of
the machine.
4.
Remove the oil filler cap 4.
7. MAINTENANCE:
NOTICE
•
Do not tilt the generator when adding engine oil. This could result in overfilling
and damage to the engine. Don't make foreign body fall into engine.
•
Oil and gasoline could pollute the environment, don't throw it in the trash or pour
it on the ground.
5. Place an oil pan under the engine.
Remove the oil drain bolt . Drain
t
he
oil from the oil tank.
6. Check oil filler cap
O-
ring
Oi
l
drain bolt
O
il fi
l
ler ca
p
pa
c
king
Replace immediately with new one if
damaged.
7. Assemble oil drain bolt and oil filler
cap packing.
8. Add oil till to a suitable level tighten
oil filler cap.
9. Assembly the end cap at the bottom
of machine.
10. Assembly the sight glass of engine
oil.
Air filter:
1.
Unscrew but unloosen the screw 1
and take off the left exterior cover 2.
2.
Remove the air filter cover and
foam element 3.
3.
Wash the foam element in solvent
and dry it.
4.
Add oil for the foam element and
squeeze out excess oil. The foam
element should be wet but not
dripping, avoid be damage.
5.
Insert the foam element into the
air filter case.