ACTEON Equipment Satelec Implant Center 2, Manual

Page: 37 / 59

- Insert the brackets into the bracket holders (Fig. 2-4).
- Connect the N
EWTRON
scaler cord or the P
IEZOTOME
2 handpiece cord to the connector (Fig. 1-7 and/or
1-8) (according to option).
- Connect the N
EWTRON
handpiece to the scaler cord (delivered according to option).
- Check that the device is close enough to the work area to be used without pulling on the cords. If it is
not, move the device closer.
- Place the N
EWTRON
or P
IEZOTOME
2 handpiece on the handpiece support.
- Suspend the bottles or bags of physiological saline or sterile water from the brackets.
- Adjust the position of your device to suit your angle of view.
4. 4 FIRST USE
Before using the P
IEZOTOME
2 for the first time, all the equipment must be given routine maintenance
and/or sterilized according to the procedures defined in chapter 11.
V - -IRRIGATION SOLUTION
P
IEZOTOME
2 is not designed to administer drugs. It must be used only with bottles or bags of
physiological saline or sterile water with an individual capacity not exceeding one litre.
VI - IRRIGATION LINES
P
IEZOTOME
2 must be used exclusively with SATELEC irrigation lines.
VII - -ADJUSTMENTS / SETTINGS / MODES / INTERFACE
7. 1 STARTUP
Important:
After stopping the device, wait four seconds before restarting it.
By default, when the device is switched on, the right-hand handpiece is selected.
If no handpiece is connected, the device selects the right side in P
IEZOTOME
mode.
7. 2 SETTINGS
The settings are saved when each program is configured and are retrieved whenever that program is
selected.
7. 3 -IRRIGATION FUNCTION
a) Flush / prime
The flush / prime function is available on the LCD screen and on the footswitch.
Press button (Fig. 3-1) or the footswitch button (Fig. 8-2) to switch on the flush / prime function.
The flush / prime function stays on as long as the button is pressed.
The flush can be switched on while the device is being used.