Acson international A5MAC 210D, Technical Manual

Page: 39 / 49

41
4) Timer Setting
1 After the “Timer” key is pressed, “Weekday Setting” and “Timer Setting” are displayed at the same time on the
LCD, indicating access to the weekday adjustment phase.
2 Press the “▲” or “▼” key to select the weekday of the timer time to be set.
3 After selection, press the “Enter” key. “Timer Setting” is displayed on the LCD, indicating that timing weekday
has been selected and setting of timing times is being accessed.
4 Upon entering the timing times, press the “▲” or “▼” key to set specific timing point of the current day
(four timing times can be set each day, and the timing No. is displayed on the left of the on/off status).
5 Press the “Enter” key to select a timing point and access selection of timed ON or OFF.
6 Press the “▲” key or “▼” key to select “Timed ON” or “Timed OFF”.
7 Press the “Enter” key to select timer ON or OFF and enter into setting of timer time mode. Now the LCD will
displays “Timer Setting” and “Time Setting” and the time blinks.
8 Press the “▲” key to change hour, and press the “▼” key to change minute. After setting time, press the “Enter”
key to complete all settings of this timing and go to step 3 . The number of timer times should increase in order
(if the previous timer times are 4, the system automatically goes to the first time of timer next day). Timing of one
week can be set cyclically until timing setting exits.
9 To cancel a timer set, set the time of the timer to 00:00 for that particular set.
10 To cancel all timed actions, press and hold “Mode” + “Unit” until you hear a long beep sound.
11 After the timer mode exits, the time display area displays the next timing action time every 2s
(it is not displayed if the unit has been powered on/off manually).
Note:
Timed ON/OFF actions are triggered when the time of the wire controller reaches the set time. Therefore, if the
time of the wire controller is inaccurate, the actual ON/OFF time will be inaccurate. If you press the “Unit”, “Mode”
or “Password” key or press nothing within 5s during setting process, the controller will exit timer setting automatically
without saving settings but the previous settings will not be affected. Unit by default is without any timer setting.
5) Manual Defrost
When the unit works in heating mode, press "▲" or "▼" until "Manual Defrosting" appears, and then press "OK" to
enter Manual Defrosting mode.
6) Reset
The controller can be reset by pressing the small hole above the "▲" key using a needle-like tool.
7) Locking the wire controller
You can lock up the wire controller by holding “Enter” for 5s. The lockup icon will be displayed on the upper right
corner. When the controller is locked up, only off and on function can be carry out by the controller.
the controller, hold "Enter" key for 5s again. The lockup icon will be cleared.
To unlock