9
1.INDICATORS UNDER DEVELOPMENT
LS 1292 INDICATES THE PROGRAMMING STATUS THROUGH THE MOVEMENT OF THE BLIND
2. MOTHER RADIO CONTROL SWITCH MEMORISATION AND OPERATING LOGIC
The first radio control switch to be memorised is known as the “MOTHER” and automatically acquires the
following characteristics:
- It establishes the roller window blind/awning direction of movement on the basis of the key used during the
memorisation phase.
- It is the only radio control switch able to activate the programming phase.
If, memorising the mother radio control, are present other LS 1292 central control on which no mother radio
control is memorised, you should disconnect these central control from electrical alimentation to avoid that
several control units memorize the same mother radio control.
Follow the instructions provided on paragraph 8 if you wish to invert the operating logic of the “MOTHER” radio
control keys.
Proceed as follows to memorise the “MOTHER” radio control switch.
1. Connect the control unit to the power supply;
2. Press and hold down both buttons of the radio control until two brief movements of the blind/awning (one up
and one down) are observed. This indicates that LS 1292 is in programming mode.
3. Press a key on the “MOTHER” radio control switch to be memorised. At this point the LS 1292 memorises the
“MOTHER” radio control switch and automatically exits from programming mode.
Pressing the “UP” button of the radio control unit raises the blind, whereas pressing the “DOWN” button lowers it.
When the blind is moving, pressing the “STOP” button will halt movement of the blind.
When the UP button is pressed in the resting position, the blind is raised. Pressing the same button again will
have no effect and the blind will continue its run. On the other hand, if the DOWN button is pressed the blind
stops. Vice versa for the down run.
3. ADDITION OF NEW RADIO CONTROL UNITS (TX COLOR - TX4 - TXP)
The “LS 1292” electronic control unit can memorise other seven radio commands in addition to the “MOTHER”. In
case you wish to add new codes in the receiver, the following procedure must be followed.
1. Connect the control unit to the power supply;
2. Press and hold down both buttons of the “MOTHER” radio control unit until the motor control unit signals the
start of programming1 through two brief movements of the blind roller shutters, one upwards and the other
downwards.
3. Press a key on the new radio control unit to be memorised. At this point the central control unit
memorises the new radio control unit and exits automatically from programming status.FIG.2.
TX COLOR
PIC. 2
LS 1292
LS 1292
LS 1292
