Aclarus AOWT-7, Operator'S Manual

Page: 17 / 53

17
Chapter Two: System Installation and Start Up
Detailed installation instructions for installation are provided in this manual. Please also
refer to the Site Specific Installation Sheet if provided with the Aclarus System for any
additional information about any custom modifications specific to your model.
Installing the Aclarus System requires these steps to prepare the site:

Plumbing the water source into the system.

Venting the off-gasses safely.

A 15 Amp 110V power outlet within four feet of the system.
NOTES:

Once installation is complete, the system must be filled, the filters
backwashed, and samples taken to ensure water quality.

If line or pump pressure can exceed 65 psi (4.5 bar), a pressure regulator is
required. The pressure regulator and bypass are not supplied.
Installation Example
Example One
Pre-filter or sand filter is occasionally
required (not shown) with high sediment,
sand or turbid water.
This post filter shown is an activated
Carbon replacement filter and must be
placed as the final filter.
For very high iron, algae or other issues
a sediment filter prior to the activated
carbon may be required. Contact
Aclarus for more information.
Example Install #1
:
Typical installation example. Post filter installed (blue casing far right) is mandatory
activated carbon filter and included with the system package.