Aclarus AOWT-7, Operator'S Manual

Page: 24 / 53

24
Filter Preparation
– Optional Media Bed Filters
Backwashing the filters:
WARNING: Complete following before allowing water to the home: cartridge
filters must be flushed before using to remove preservatives. Drain flush water
because it is not safe for consumption. Filters may come pre-washed
– check
with your filter supplier.
1. For auto backwash filters(s) connect to appropriate power source.
2. Remove all aerators/screens from fixtures, including taps. Do not use toilets during
this process. Small particulates of media can plug fixtures.
3. Review manual for the specific setup directions for your model and filter brand
installed.
4. Once filter is installed, setup, and in service, immediately perform a backwash on
each filter.
NOTES:

only backwash one filter at a time and wait for filter to complete cycle before
initiating second filter backwash (if required)
– follow instructions that come
with the filter for manual backwash.

Aclarus System will be running during filter backwash to clean the filter media
with ozonated water if set up properly.
5. After the filter has finished cycling, open the outgoing valve on the bypass
assembly.
NOTE: If Aclarus system is equipped with more than one filter, repeat steps 1 to 4
for each filter.
6. Once all filters are finished backwashing run the tap closest to the Aclarus system
for three to five minutes to flush any small particulates may have come through.
7. Replace aerators/screens in fixtures (taps).
8. Open all valves slowly for water supply to enter the existing infrastructure and
ensure existing plumbing fills slowly to minimize water-hammer effect.