Wire Rope Hoist
PAGE: 22
Model WR
WR-0214
2721 NE 4
th
Ave Pompano FL, 33064 | (954) 367-6116
Visit WWW.ACIHOIST.COM for the most current information
Mounting the rope
While mounting the rope through the hook and the roller of the reeving system make sure the rope won’t twist. The load
block on new hoists or after installation of replacement rope may turn when a load is applied or released. Such load
block turning may cause the lines of rope to twist about each other. Do not operate the hoist in this condition. This
indicates a twist was induced into the rope during installation. Remove the rope from the hoist, lay the rope out to
remove any twist, and re-install on the hoist.
Instructions for mounting wire rope on the hoist are outlined below in Figure 4.2.3.
Figure 4.2.3
4.3 Installation of Base Mount Electric Hoists
There are two options to install a base mount electric hoist to a plane:
On to a horizontal plane (standing modification). (Figure 4.3.1 A & D)
Under a horizontal plane (under hung modification). (Figure 4.3.1 B)
On request the stationary electric hoists may be manufactured to be installed on a wall (Figure 4.3.1 B).
