Acer TRAVELMATE 7730, Service Manual, Page: 94 / 254

86
Chapter 3: Replacing notebook components
10
Taking care to note the cables’ routing and positions as they are installed from
Acer, pull the antenna cables out from under the system board, then slide the
antenna cables and LCD cables out from under the retaining clips.
11
Remove the screws on the top that secure the LCD panel hinge to the chassis.
12
Lift the LCD panel assembly up and away from the notebook.
13
Place the new LCD panel assembly onto the notebook, then replace the hinge
screws removed in Step 11 .
14
Slide the antenna cables through the retaining clips, then under the system board.
15
Slide the LCD cable through the retaining clip, then plug it into the notebook.
16
Replace the keyboard by following the steps in “Replacing the keyboard” on page
80 .
17
Replace the keyboard cover by following the steps in “Replacing the keyboard
cover” on page 78 .
18
Close the LCD panel, turn the notebook over so the bottom is facing up, then
replace the bottom hinge screws removed in Step 6 .
19
Route the antenna cables into the wireless bay, then reconnect the antenna wires
to the wireless card by following the steps in “Replacing the IEEE 802.11 wireless
card” on page 67 .
20
Replace the wireless bay cover by following the steps in “Replacing the IEEE 802.11
wireless card” on page 67 .
21
Replace the memory bay cover by following the steps in “Adding or replacing
memory modules” on page 57 .
Screw Screw Screw Screw