Acer Altos G540 M2 Series, User Manual

Page: 147 / 221

139
Initial troubleshooting checklist
Use the checklist below to eliminate the possible cause for the problem
you’re encountering.
• AC power is available at the wall outlet?
• Is the power supply module properly installed?
• Is the system power cord properly plugged into the power supply
module socket? and connected to a NEMA 5-15R outlet for
100-120 V or a NEMA 6-15R outlet for 200-240 V?
• Are all peripheral cables correctly connected and secured?
• Did you press the system power button to turn the server on
(power on indicator should be lit green)?
• Are all device drivers properly installed?
• Is hard disk drive(s) properly formatted and configured?
• Are the BIOS configuration settings in the BIOS setup utility
correct?
• Is the operating system properly loaded?
Refer to the operating system documentation.
• Are all hardware components compliant with the tested
components lists?
• Are all internal cables correctly connected and secured?
• Are the processors fully seated in their mainboard sockets?
• Are all standoffs in the proper location and not touching any
components, causing a potential short?
• Are all add-in expansion cards fully seated in their mainboard
slots?
• Are all system jumpers correctly set?
• Are all switch settings on add-in boards and peripheral devices
correct?
To check these settings, refer to the manufacturer’s
documentation that comes with them. If applicable, ensure that
there are no conflicts (e.g., two add-in boards sharing the same
interrupt.