AXS
–
Ramp Manual
AXS FL RAMP Manual rev 1
22
Place the lock plate (red part in
picture) in the lock on the bottom
plate and close the lock. Make
sure the lock plate is aligned with
the side of the bottom plate.
Align the ramp / bottom plate
with the rear of the vehicle floor.
Make two centre points in the
floor - with a drill of 8 mm drill
through the two holes from the
lock plate. Then remove the lock
plate and drill with a drill of 11
mm through the floor.
If the ramps needs to be stowed
at the 90 deg inside position,
repeat this exercise in this
position.
Left or right version mirrored
Fix the lock plate(s) with enough
spacers at the floor. Adjustment should
be made in such a way that the bottom
plate slides easily under the lock plate
with very little play.
Use the U shaped counter plates under the
vehicle floor
Ramp stop / Ramp Anti rattling device.
You will also need to install the ramp stop at the
door to prevent the ramp for rattling or hitting
against the rear door/window. `
We recommend positioning this as high as
possible at the door
The bracket needs to be fitted with the
two rivet nuts M8. (Drill Ø11 mm
holes).
Position the bracket so that the rubber
aligns with the rail of the ramp.
Place brackets left and right
Adjust the brackets so the ramp is
held tight when the door is closed.
