AXS
–
Ramp Manual
AXS FL RAMP Manual rev 1
10
7
Installation of options
7.1
600 Kg leg kit
This installation should be done at an
installed ramp in the car.
It is possible at ramps in stock but you
need to unfold the ramp.
Needed tools:
Allen key 6 mm + 3 mm
Warning: Always check the position of the T
nuts after fitting. They must be at an straight
angle with the slot in the Alu profile
Needed parts
Leg kit AR 200 073
Unfold the ramp.
Remove the centre gas spring including the
ball joint from the bracket on platform 1 by
unscrewing the M8 nut holding the ball joint in
place.
Remove the mounting bracket and leave the t
Nuts in the slot from the side profile.
- mount the bracket of the leg using the T nuts
of the previous bracket following beside
picture.
- Make sure it is mounted as far to the plastic
end cap as possible.
- Tighten the bolts M8 (30 Nm)
- check the position of the T nuts
