AXS
–
Ramp Manual
AXS FL RAMP Manual rev 1
20
Once you have determined the position of the turning
point drill a hole of 11 mm in the floor at the turning
point.
Than drill a second hole of 11 mm at a center distance
of 110 mm from the first hole, in the direction of the
side of the vehicle so that the strip stands at 90 deg
with vehicle direction.
Fix the strip from the pole with the M10 wire struts through
the floor. (you will need to remove this later)
Move the top fixation bracket as close as
possible to the wall. Then position the two
fixation 90 deg brackets on the wall and
position at a place where you have a firm
counter section in the wall.
Note that all brackets are adjustable.
Drill two 11 mm holes and fix the rivet nuts
in the wall.
Do not fix the brackets yet!
Left or right version mirrored
Remove the turning device from
the vehicle and fix the ramp to
the turning device using the 4 x
M10 countersunk bolts.
Once fitted to the turning plate,
remove the steel and wooden
distance piece between the feet
assemblies
Left or right version mirrored
