AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
16
10.2 Assembly
Most of the assembly is just the reverse version of the disassembly described above, however there
are some points to note, these are described below
Pull the step out of the frame
entirely
Remove the sliding
blocks
When putting the motor back in place
-
Put a firm bit of grease at the gear.
-
Place the nylon washer at the gear and place the
reinforcement plate.
-
Let the motor run and check the Amps. Nominal 2,5
Amp - max 2,8 Amp
Fit the two Magnetic switches at the motor base plate.
Motor assembly is now ready for final assembly.
When placing the two round rubber
grummets in the opening of the rear step
profile, Use liquid soap to make the job
go easy.
Take the two arm gears; take a paint
brush with a firm bit of grease. Grease
the gears from the gear arms.
Put grease at the nylon rings and place
them at the gear arms. Slide the distance
bushing in the nylon rings.
