AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
5
6
Operation
6.1
Deploy Operation procedure
The step must have clearance from the vehicle. The vehicle
must have the parking brake on, and then the step can be
safely operated.
The electronics receive a signal from the door switch or driver
switch. If a door switch is installed the step will move out
automatically once the door is opened.
Time for either the full deploy / out or the full stow / in cycle is
approximately 2.5 seconds. When the step is moving the red
LED on the dashboard will flash until the step is completely out.
If the step encounters an obstacle it automatically stops. It will move backwards for a few centimeters
and then move forward again. If there is still an obstacle it will repeat this procedure three times, then
it will stop in the position where it encountered the obstacle.
6.2
Stow operation procedure
To stow the step the door should be closed or the driver has to give a signal that the step should stow.
The same rules apply as for moving out.
At closing a signal from the close switch will indicate that the Step is completely closed. This close
signal will also give the vehicle the OK that it is safe to drive the vehicle away, the Red LED light at the
dashboard will go off. If the step is not stowed properly the RED LED keeps blinking.
Step moving = Blinking LED
Step out = Shining LED
Step in = LED off
