AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
10
•
When installing the switch using the nuts, the switch
must stick out at least 12 mm because of the need for
magnetic flow around the switch.
•
The distance between the end of the switch and the
door should still be 7 mm.
IMPORTANT: Max torque to fit the switch is 5 Nm (This is light hand tight)
If
you use higher torque, the switch will break / crack, which will lead to unreliable
door
signals.
•
Place the red LED in the dashboard in the direct view of the driver. Connect the free wire to 12 V
power. The LED lights up red when the step is out and flashes when the step is moving in or out.
•
Connect the black wire to ground.
•
Connect the red wire to 12V power.
You need to add a fuse of 20 Amp
between
the battery and the power cable. Decide whether to connect the step to constant
power or to power behind the main switch. We recommend placing the step behind
the main switch. The step ECU has a sleep mode using less than 1 mAmp in standby
mode
•
Connect the cable loom to the step with the connector. Place this connector
preferably inside the vehicle in a dry area.
•
The step is now ready for operation.
If you decide to use driver operation, place a
switch on the dashboard and connect it to the
Green wire. Closed signal => step out. Open signal
=> step stowed. To prevent oversight from the
driver’s point, also install the door switch to preve
nt
driving with the step in outward position.
