AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
3
2
Technical specifications
Product description
Electric operated step for mounting outside under the floor of a vehicle.
Installation
Under the vehicle Floor at the front- middle or rear door
Dimensions
Step depth 300 mm - width depending on model 600, 900 or 1000mm
For detailed dimensions please refer to the installation drawings
Weight
total 24-28 Kg depending at model.
Load
Maximum load 200 Kg (2000 N) this is always labeled on the Step.
Materials
Frame; steel plate work, EP corrosion protected.
Step: Aluminum profile plastic front edge and Plastic corner pieces.
Life cycle
Tested life cycle of the step is 100.000 cycles.
Electrical connection Waterproof 4 pin connector (IP65) on the step.
Power consumption max average 4 Amp short peak up to 15Amp, sleep current < 5mA
Drive
Electric motor 12V 20W (or optional 24V at special demand)
Electric signals
following electric signals are available: Step closed / stowed.
Safety functions
Motor switched off by current control.
Cycle time
Time required for opening or closing the step is approx 2,5 Sec
Legislation
The product fulfils R 107 UN Bus directive and 2006/42/EC / 98/37 EC Machine
directive.
3
Safety instructions
These Safety instructions should always be with the step. The operator must be
made aware of these instructions before operating the Step. Read these safety
instructions carefully and follow them.
The step is constructed to be an extra step to enter a vehicle. It should be used appropriately by
passengers as long as they are not heavier as the maximum load, to enter or exit a minibus, taxi,
camper or other vehicle.
1.
Before you can operate the step you have to stop the Vehicle and make sure that the
hand or park brake is on.
2.
Before you operate the step, make sure that there is no person or obstacle at or close to
the step. Look out that there is no person or obstacle outside the vehicle in the motion
direction of the step.
3.
It is recommended that the step is only operated by the driver or other qualified
operators.
4.
The driver or operator must have a clear view at the step when he is operating the step.
5.
It is recommended to step on the middle of the step platform.
6.
NEVER drive away when the RED dashboard LED light is still on. The step is not properly
stowed.
7.
The step platform must be kept clean and free of oil and other slippery materials.
8.
When you have any doubt about the safety of passenger when using the step make sure
he is assisted.
9.
For any questions about the safe operation of the step, directly contact the responsible
persons.
10.
Never use the step for any other use than here described.
11.
Never overload the step.
12.
The step should always be operated until it is fully in or out.
13.
Repair and maintenance must be done by qualified and trained staff only.
14.
Only use original parts if you have to exchange parts from the step.
15.
If the anti-slip profile at the step becomes slippery because of wear, the step platform
must be replaced.
16.
Always use the recommended cleaning materials.
17.
Report any unsafe condition of the step, or during it’s operation, to the step supplier.
