DGA-6000 ULTRA-HD VIDEO GENERATOR / ANALYZER USER MANUAL
23
HDCP InfoPane
Heading
- HDCP Status
Modes
– Analyzer input HDCP version. Select Off, v1.x, v2.2.
Allow up to 10 seconds for the source, analyzer, and monitor to properly re-establish HDCP
communications and possibly change to a different video format. An HDCP 2.2 source will often switch to
a lower resolution output format when the input port has a lower HDCP level. When switching the input to
a higher HDCP version it may be necessary to disconnect and reconnect the input cable for a source to
change HDCP levels and possibly switch to a higher resolution video format.
Displayed Data –
Analyzer input and output HDCP status.
Analyzer Input
Port:
HDCP version of Analyzer input port (Mode selectable)
Signal:
HDCP version of Analyzer incoming signal
Analyzer Output
Monitor:
HDCP version of the connected Analyzer monitor
Signal:
HDCP version of Analyzer output signal
AR InfoPane
Heading
- Aspect Ratio
Modes
– Select Auto, Auto[c] (show cursor rectangle), Manual (set cursor rectangle)
Set
active picture detection Threshold: 0-32 (default 16)
Displayed Data –
Active picture area (Auto) or cursor rectangle (Auto[c], manual)
L: (left), R: (right), T: (top), B: (bottom),
W: (width), H: (height)
,
AR: (aspect ratio)
Cursors
– set in Manual mode only
L:
– use Left/Right keys
R:
– use Left/Right keys
T:
– use Up/Down keys
B:
– use Up/Down keys
Press the Cursor key to select L:T: rectangle edges or R:B: rectangle edges
InfoFrame InfoPane
Select InfoFrame Type (listed in the following section) from the Analyzer sub-menu InfoPane/IF Type.
EDID
Read the EDID of a display or other device by connecting it to the Analyzer’s Monitor output.
Currently only available via a USB command. Refer to Appendix A, the USB Interface Manual.
