DGA-6000 ULTRA-HD VIDEO GENERATOR / ANALYZER USER MANUAL
13
Menu Navigation
The main Generator and Analyzer Menus are organized into three columns. The left column of the
Generator Menu lists eight sub-menus – User, Output 1, Output 2, Info, Misc, Defaults, (AVI) InfoFrame, and
3D Mode. The left column of the Analyzer Menu lists three sub-menus – PixelPane, InfoPane, and Settings.
Whenever those Menus appear on screen the cursor keys (pointed keys
surrounding the Enter key) can be used to move up, down, left, or right
to select items within the menus. The selected items will be highlighted
in green. Use the cursor keys to select the desired sub-menu in the left
column, and then move into the middle column and highlight a sub-menu
item. The current status of each highlighted sub-menu item is shown in
the right column. To change a setting move into the right column and
highlight one of the settings listed in that column. In most cases it is not
necessary to press the Enter key unless “Enter” appears in the right
column. In that case highlight “Enter” and press the remote control Enter
key to proceed.
Press the Menu button to turn the OSD menus on or off. The highlighted cursor position in the OSD menu is
retained when the menu is turned off, so it is easy to turn the menu off when making measurements or
adjusting a calibration setting, and then turn it back on again to make additional changes to the same menu
item. It may be necessary to press the menu key multiple times to cycle back to the desired main menu as
discussed in the previous section.
Menu items that are not applicable to the current signal Output type or Format are dimmed and not
accessible in the menu. For instance, the YCbCr 4:2:2 Filter selection menu item is not accessible unless
the YCbCr 4:2:2 output mode is active.
Generator Pattern Information Bar
Pattern Info
– Each time a pattern is changed the name of the pattern, which may include important signal
identification information, is displayed on-screen for a short duration. The duration can be selected in the
Generator Misc sub-menu (approximately 0.25, 0.5, 1.0, 1.5, or 2.0 seconds), and the duration can be saved
as a power-up default value. Press the Info button on the remote control to display the Pattern Information
Bar continuously. Press the Info button again to resume the default display period.
CIE xyY values are shown on the Pattern Information Bar for windows and fields in the Color75 and
Color100 pattern groups. The CIE x,y and Y (luminance relative to an equal amplitude gray color) values are
defined by the Color Gamut of applicable UHD, HD or SD standards, and can be used as target values to
adjust a Color Management System (CMS). It can be advantageous to calibrate a display to have selectable
Color Gamuts for the same signal format, therefore the displayed Color Gamut targets for HDR, SD 60 Hz,
and SD 50 Hz signals can be changed in the Generator Misc sub-menu. The Color Gamut selection
changes only the CIE xyY target values in the Pattern Information Bar, and does not affect the generator’s
output signals
.
