45
Front and Rear brake fluid level check and
refilling
*
Brake fluid level check
1. Position the handlebars in the middle. Check front and rear
brake fluid levels in the reservoirs. Fluid level should be
between upper and lower limits.
2. When the fluid level drops to the lower limit, check the
condition of the brake shoe wear.
3. If the brake shoe wear is within the specified limit, then it
normally represents that there is leakage in the system. Ride
your ATV to the dealer
’s workshop or service center for
inspection.
*
Brake fluid refilling
1. Position the handlebars in the middle. Remove two fixing
screws on the cover of the brake fluid reservoir, and then
take out the cover.
2. Refill brake fluid, recommended DOT-4 grade, until it reaches
the upper limit. Then, position back the cover and tighten two
fixing screws.
3. Change brake fluid once a year.
Notes:
1. Do not mix brake fluid of different brands or grades, which may
lead to brake failure and the risk of hazard.
2. When changing brake fluid, cover the painted area with cloth to
prevent painted surface from being damaged by brake fluid.
Summary of Contents for AX600 EFI 4x4
