Access AX600 EFI 4x4, Owner'S Manual

Page: 69 / 72

65

Replacing the fuse
Turn off the ignition switch and check if the fuse is blown.
When replacing the fuse, always get a fuse of the specified
rating.
＊
Before replacing the fuse, first find out why it is blown.
＊ Remove the front rack and cover.
＊
The fuse is located nearby the battery.
＊
To remove the fuse:
Open the fuse cover and take out the blown fuse.
If the fuse is not well in contact, it will create heat and
easily leads to circuit failure.
＊
To assemble it:
Insert the fuse in the holder and position the cover
back in place.
Be sure to gently pull the fuse to ascertain that the
fuse has good contact. A loose fuse will generate heat.
＊
Fuse rating: 5A, 10A, 15A, 30A and 35A.
Notes:
1. To replace the battery (lamps), use only the original
components of the prescribed specification.
2. If components are not original or out of specification, the fuse
can easily be blown, and the battery will not be in balanced
status.
3. When washing the ATV, do not wash it with high-pressure
water jet.
Notes:
＊
To remove the fuse:
Care should be taken when removing the fuse, as its holder is
very small. If the fuse does not have good contact after
opening the cover, it may generate heat and lead to circuit
failure.
＊
To assemble the fuse:
Insert the fuse in its holder.
Be sure to gently pull the fuse to ascertain that the fuse is well
in contact. A loose fuse will generate heat.
Fuse box Cover
Fuse