Access AX600 EFI 4x4, Owner'S Manual

Page: 44 / 72

40
7. Apply a thin coat of engine oil to the O-ring of the new oil filter
cartridge.
8. Install the new oil filter cartridge with an oil filter wrench, and
then tighten it to the specified torque with a torque wrench
.
9. Install the panel A.
10. Install the engine oil drain bolt, and then tighten it to the
specified torque.
11. Add the specified amount of the recommended engine oil,
and then insert the dipstick completely into the oil filler
hole.
12. Start the engine, and then let it idle for several minutes while
checking it for oil leakage. If oil is leaking, immediately
turn the engine off and check for the cause.
13. Turn the engine off, wait at least ten minutes, and then
check the oil level and correct it if necessary.
14. Install the panel.
Note:
* Make sure that the O-ring is properly seated.
Tightening torque: oil filter cartridge
17Nm (1.7kgf-m)
Tightening torque: engine oil drain bolt
30Nm (3.0kgf-m)
O-ring
Torque wrench