On Your Device
1.
Select the
Tools
key on the front of the case or select the
Tools
key to the right of the text
display area.
2.
Select the
Toolbox
key.
3.
In the Toolbox, select
Output Menu
.
4.
Set Output to
On
.
5.
Set Output Destination to
External
.
6.
Set Output Method to
USB
.
7.
Set Host Computer to the type of computer you are using:
IBM
(PC) or
Mac
.
8.
Select
OK
to exit the menu.
Setting Up Infrared (IR) for Remote Controls
IR capability is enabled automatically with the Accent. The IR area of your device is on the back
of the case on each side of the headphone jack, near the top. When you are facing the front of
the device, the
IR Learning Receiver
is on the top left and the
IR Transmitter
is on the top right
of the IR area.
You can teach infrared signals for almost any appliance you own that has a remote control. If you
want to teach a remote control signal to your device, point your remote control at the IR area.
If you want to send an IR signal from your device, make sure the IR area is facing in the general
direction of the appliance you want to send the signal to.
Use the IR Setup Menu in the NuVoice Toolbox to teach remote signals to your Accent. The
following IR functions can be performed in NuVoice by using
IR Setup
Menu
in the Toolbox:
•
Add, modify, delete, or rename a device/appliance
•
Add, change, delete, and test IR functions
Adding a Device
Several devices are already set up in the Accent. You only need to teach the signals to your
device. To add additional devices, select
Add a Device
and follow the instructions on the display.
Accent 800 Hardware Manual
Page 19
