IN A HURRY - READ THIS
For those who don’t like to read manuals or would like to read the
manual later, please read at least the following section.
SmarTouch Digital comes to you with a universal set
of default settings. If you choose to keep these
settings, then you only need to remember 2 things :
how to set the spa temperature and to press the SET
key whenever you are done using the spa.
Setting Temperature
♦
Press and hold the TEMP key for 2 seconds. Release all keys
The display will flash the current selected temperature.
♦
Using the TEMP and TIME keys (UP and DOWN arrows)
scroll to the desired temperature.
♦
Press the SET key to lock in the new selection
The SET Key
After using the spa, press the SET key to tell the microcontroller you
are done using the spa. It will then take over the spa’s management
including the different filtration cycles, heat maintenance, economy
modes and protection against freezing.
Upon entering this mode the FILTER light is turned on and a post use
filtration cycle is executed - that is when the spa needs filtration the
most. The default system setting includes a 3 hour economy mode,
the pump will come on at most once every 3 hours to sample water
temperature and heat if necessary. The controller remembers when
you have used the spa and in anticipation of your next usage will
perform a 3 hour Auto Filtration cycle before your next spa use.
SmarTouch Digital Series 1000 and 2000 is a family of intelligent, spa
control systems. These systems are rich with features and can be
extensively programmed to fit just about any need. The rest of this
manual will explain the function of each of the keys on the control
panel, how to change programmed settings and what each setting
does. It will also explain all the error messages that you may
encounter, and their significance and way to correct them.
Page 5
