10
������������ ���� ���������� ������������
ABS lifting station Sanimat
S�bm����b�� ��m�� AFP M15 ,M ,M30 , M40 ���� M60
Locate vibration damper (3) at the pump head support (2).
Fit the pump head support through ”Eyelet A” at the pump head.
Adjust the vibration damper (3) so that the rubber support rests on the ground and fix the vibration damper (3) in
position using hex nuts and washers.
Submersible pumps AFP M40 and M60
Locate vibration damper (3) at the pump head support (2).
The pump head support (2) is rotated by 180° and fitted via “Eyelet B” as shown in Figure 8.
Set the vibration damper (3) so that the rubber support rests on the ground, and fix the vibration damper (3) in
position using hex nuts and washers.
S�bm����b�� ��m� AS S1 & S6
Place the vibration damper (6) at the pump head support.
Screw the pump head support (5) into the pump head using socket head screw (4).
Adjust the vibration damper (6) in such a manner that the rubber support rests on the ground and fix the
vibration damper (6) in position using hex nuts and washers.
4.6
L�v�� C������
The level control is a pneumatic system with submerged tube and control pipe (plastic hose) to the control unit.
The submerged tube is permanently installed in the collection tank. The required switching and control devices
are installed in the control unit.
1085-00
Figure 9 Installation of the control pipe
1
Control unit
5
Spigot nut
2
Connection nipple
6
Submerged tube nut SW 36
3
Twin control line
7
Submerged tube
4
T-connection piece
8
Tank
ATTENTION
The control unit itself (1) should be installed above possible flood level in such a
manner that the control line (3) has a continuous rise to it.