Alliance Intelligent Battery Series
TM
User’s Guide
© 2020 American Battery Solutions Inc. All rights reserved. The data herein is intended as a guide and does not reflect the specification range for any particular property of this
product. Such data is based upon analysis of representative samples and not the actual product shipped. We based the information on data believed to be reliable on the date
compiled, but we do not represent, warrant, or otherwise guarantee, expressly or impliedly, the merchantability, fitness for a particular purpose, freedom from patent
infringement, suitability, accuracy, reliability, or completeness of this information or the products, materials or processes described.
Page 30
b.
IGN-Based Wakeup
The Alliance Intelligent Battery Series™ can be woken by connecting the Ign Low
(Pin 2 of the low voltage connector) to the negative terminal of the battery or
connecting the Ign +12V to an external 12V source. (It is assumed that
connection to the negative terminal of the battery is through chassis ground or
the application wiring harness.) When either Ing pin is activated (Switching Ign
Low to ground or applying 12V to Ign +12V) will enter Drive mode (assuming no
failures are present), at which point Discharge and Charge functions are
available. The BMS will enter sleep mode within 5 seconds of removing the
Ignition signal.
Pins on the Alliance Intelligent Battery Series™ low voltage connector that are not
used should be left not connected (NC).
Figure 7: CAN Connector Pin-out
Battery Management System (BMS) Modes of
Operation
The Alliance Intelligent Battery Series™ has 5 Major states of Operation:
1.
Standby Not Ready (fault condition present)
2.
Standby
3.
Drive
4.
Charge
5.
Sleep
