Aber Hot Tub Manufacturing Pacific 2004, User Manual

Page: 45 / 58

Low level programming
Functionality Hold Econo key for 20 seconds, 1st parameter will appear (Up/Down keys modify values)
Duration Press Econo key to display next parameter, System will reset after last parameter.
Display As table below, Default values in bold.
Parameter Display Value of x
Pump #1 P1 x 1 = Single speed 2 = Dual speed
Pump #2 P2 x 0 = Not installed 1 = One speed 2 = Two speeds
Pump #3 P3 x 0 = Not installed 1 = One speed
Blower bL x 0 = Not installed 1 = One speed 2 = Two speeds 3 = three speeds
Light LI x 0 = Not 1 = 12 VAC 2 = 12 VAC 3 = 120 VAC 4 = INTERNAL
installed (single (three Fibber box
intensity) intensity)
Ozone O3 x 0 = Not installed 1 = on only 2 = always on 3 = on with
during Filter the circulation
cycle pump
Circulation Pump CP x 0 = Not installed 1 = regulated 2 = always on 3 = always on
(with spa but off when
temperature) 2 degrees over
set point
Filtration cycle FC x 1 = filtration cycle enable 2 = Filtration cycle replaced by a purge cycle
Pressure switch PS x 0 = with pump one 1 = with the circulation pump
(CP can not be at 0)
Time out output To x 0 = 20 minutes 1 = 30 minutes 2 = 40 minutes
Current pump #1 C1 x Select the current of the pump #1 (1 – 15)
Current pump #2 C2 x Select the current of the pump #2 (1 – 15)
Current pump #3 C3 x Select the current of the pump #3 (1 – 15)
Current blower Cb x Select the current of the blower (1 – 8)
Current heater CH x Select the current of the heater (12 – 23)
1.8 Jumper configuration
Jumper Number Function Position 1 (Left) Position 2 (Right)
JMP-1 Input Current Mode HC The Heater will be LC The Heater must not
turned off if more than be turned on if ANY
two pumps are activated pumps (1, 2 or 3) are at
on high speed. high speed.
JMP-2 Keypad Keypad with 10 keys Keypad with 8 keys
JMP-3 TSC TSC-4 TSC-8
JMP-4 TSC TSC-47 TSC-8
Note: Keypad with 10 keys mandatory if Pump #3 or RTC required. Factory Default values in bold (for CP installed).
*If CP not installed is chosen then software will automatically default to Pump #1.
46
PA C I F I C H O T T U B S O W N E R ’ S M A N U A L