Aber Hot Tub Manufacturing Pacific 2004, User Manual

Page: 28 / 58

Use Up or Down arrow key to change setting (from 1 to 4).
Press Light key again to set temperature unit (F or C).
When the desired setting is displayed, press Light key to save all settings and exit.
An irregularly flashing “Filter Cycle” indicator means that the system has stopped filtering after 3 hours
because the water temperature exceeds the Set Point by more than 2°F (1°C). If the temperature cools
down to 1°F (0.5°C) above Set Point before the scheduled end of the cycle, filtering will resume for the
remainder of the programmed duration. Note: After a power failure, the filter cycle duration will return to
its default value (1 hour). In this case, the first filter cycle will start 12 hours after power has been restored.
Lock Panel
This feature is especially helpful when young children have access to the keypad. In Lock mode, all keypad
functions are locked but automatic features run as usual.
To activate or deactivate Lock mode, press (in this order)
Pump 1 , Light and Pump 1 again.
When keypad is locked, the display will toggle between the “LOC” message and the current water
temperature. If a power-up occurs, the keypad will be unlocked.
Celsius or Fahrenheit Display
During normal operation, the display shows the SPA water temperature in F or C. To program these system
parameters, the Light switch must be held for 5 seconds. After this time, the first parameter will be displayed:
xx
Value xx : filter cycle duration
Use the Up/Down keys to modify its value and Light key is used to accept the new value.
Press Light key will be displayed: xx
Value xx : filter cycle frequency
Use the Up/Down keys to modify its value and Light key is used to accept the new value.
Press Light key again to set temperature unit (F or C)
When the desired setting is displayed, press Light key to save all settings and exit.
Jets One
Press Pump 1 key to turn Pump 1 on at low speed. Press a second time to turn Pump 1 at high speed. Press
a third time to turn Pump 1 off. A built-in timer will turn pump off after 20 minutes unless it has been manually
deactivated.
The “Pump 1” indicator lights up when when Pump 1 is on at high speed. It flashes when pump is on at
low speed.
Press Pump 2 key to turn Pump 2 on at low speed. Press a second time to turn Pump 2 at high speed. Press
a third time to turn Pump 2 off. A built-in timer will turn pump off after 20 minutes unless it has been manually
deactivated.
The “Pump 2” indicator lights up when when Pump 2 is on at high speed. It flashes when pump is on at
low speed.
Suspension mode:
The Suspension mode is designed to facilitate filter changes, maintenance, etc. In this mode, all automatic
features are disabled (e.g. heat and filter cycle). The only automatic feature that remains active is the Smart
29
PA C I F I C H O T T U B S O W N E R ’ S M A N U A L