Troubleshooting Guide
PHT 2004 ULX Controls
(ULXT models)
Gecko MSPA-PACK
OWNER TROUBLESHOOTING
Pumps have started up for one minute on several occasions and “Filter Cycle” icon is flashing.
Not a bug but a feature!
Our Smart Winter Mode protects your system from the cold by turning pumps on for one minute several times
a day to prevent water from freezing in pipes.
3 flashing dots are displayed.
A problem has been detected.
Do not enter the water! Check and open water valves. Clean filters if necessary. Check water level. Add water
if needed. Shut power off and power your spa up again to reset the system.
Call your dealer or service supplier if problem persists.
Water temperature is flashing.
Water temperature in the spa has reached 112°F (44°C).
Do not enter the water! Allow the water to cool down. The system will reset automatically when water reaches
109°F (43°C).
Call your dealer or service supplier if problem persists.
Filter cycle stops and “Filter Cycle” icon is flashing.
Not a bug but a feature!
To prevent excessive water temperature caused by too long filter cycles, the system will cancel a filter cycle
after 3 hours if water temperature exceeds Set Point by more than 2°F (1°C).
The display is flashing.
A power failure has occurred. Press any key to reset the system. After a long power failure, you may have to
reset the time.
40
PA C I F I C H O T T U B S O W N E R ’ S M A N U A L
Summary of Contents for Pacific 2004
