Aber Hot Tub Manufacturing Pacific 2004, User Manual

Page: 15 / 58

Factory Programming
PHT 1000 and 2002
(T & LT models)
Mini Max Digital – r09/r59 Factory Programming Procedure rev:0/5
Power-up system and “Pur” is displayed on topside panel for 30 seconds while in
purge mode. Regular operation will then assume.
Press Heat and Light key until “r--” appears. “r--” is the revision level of the system
that is being programmed. This is for system ID and is not adjustable. This revision
level may change as additions or changes are made to the system.
HC or LC will appear. Press Jets One key to toggle from HC to LC operation. HC (Hi
Current) operation allows heat capability at any time where LC (Low Current)
operation will drop out the heater if Pump 1 high speed, Pump 2, or the blower is
activated. When choice is made press
Heat key to go to next mode.
100 to 106 or 38 to 41 will appear depending on the Celsius or Fahrenheit set up.
Press
Jets One key to change value for maximum temperature set capability for
regular use. When choice is made press Heat key to go to next mode. Set at 104°F
or 40°C.
P10, P11 or P12 will appear. Press Jets One key to change operation.
P10 = Pump 1 two speed with off position.
P11 = Pump 1 single speed.
P12 = Pump 1 two speed.
When choice is made press
Heat key to go to the next mode.
P6 or P12 will appear. Press Jets One key to toggle between P6 or P12 to set the
system purge time.
P6 = Purge every 6 hours.
P12 = Purge every 12 hours.
Press
Heat key to go back to run mode. Recommend P12.
Dealer Use Only
16
PA C I F I C H O T T U B S O W N E R ’ S M A N U A L
These programming
instructions are for
the installer of the
spa pak and should
not be issued to the
end user. There are
separate operating
instructions in the
manual.