ABB Symphony Harmony Series, Instruction, Page: 214 / 402

Station Problem Reports
WBPEEUI240751C0 8 - 9
To allow tracing I/O block related problems, the device prob-
lem report includes:
•
I/O device definition function block number (FC 221).
•
Device label.
•
Error type (Table 8-4 ).
The I/O channel problem report includes:
•
Channel function block number (FC 222, 223, 224, or
225).
•
Channel label.
•
I/O device definition function block number (FC 221).
•
Device label.
•
Error type (Table 8-4 ).
Station Problem Reports
An IISAC01 Analog Control Station connected through a
CIO-100 block is considered a remote station. To allow tracing
Duplicate label Device Controller detected a device label
defined the same on more than
one I/O block; duplicate device
labels are not permitted. Redefine the device label for one
of the blocks. Refer to
Duplicate
Labels
in Section 6 for further
explanation.
Hnet channel A
or B relay fault Device One of the relays that isolates the
I/O block from Hnet has failed. Replace the I/O module.
No response
(offline) Device I/O module missing, not inserted
properly, or no power. 1. Verify I/O module is present and
inserted properly.
2. Verify the I/O block is powered
up. If not, refer to Table
8-2 for
power problem corrective actions.
3. Reset the I/O module.
Suspect
condition Channel Refer to Suspect Condition in Section 6 for an explanation.
System output
alarm Device Refer to Block Power in Section 3 for an explanation.
Table 8-4. I/O Block Problem Reports
(continued)
Error Type Description Corrective Action