ABB i-bus
KNX
Start-up
22 2CDC501049D0201 Rev. A | SV/S xx.xxx.x.1
3.3.1
Parameter window General
Send communication object "In operation"
Options:
no
send value 0 cyclically
send value 1 cyclically
The communication object
In operation
indicates the presence of the device on the bus. This cyclic
telegram can be monitored by an external device. If a telegram is not received, the device may be
defective or the bus cable to the transmitting device may be interrupted.
no
: The communication object
In operation
is not enabled.
•
send value 0/1 cyclically
: The communication object
In operation
(No. 0) is sent cyclically via KNX.
An additional parameter appears:
Sending cycle time
in s [1...65,535]
Options:
1…60…65,535
Here the time interval, at which the communication object
In operation
(No. 0) cyclically sends
a telegram, is set.
Enable communication object
"Request status/measured values" 1 bit
Options:
no
yes
This communication object is used for requesting status and measured values. If it receives a telegram
with the value 0 or 1 (depending on parameterization), measured values (communication objects 2-5) are
sent via the bus. Status values (communication objects 6-7) are sent depending on parameterization
•
yes
: The 1 bit communication object
Request status/measured values
is displayed. An additional
parameter is displayed:
Request with object value
Options:
0
1
0 or 1
0:
A telegram with object value 0 triggers sending of measured and status values.
1:
A telegram with object value 1 triggers sending of measured and status values.
0 or 1:
A telegram with object value 0 or 1 triggers sending of measured and status values.
Summary of Contents for SV/S 30.160.1.1
