ABB SV/S 30.160.1.1, Product Manual

Page: 21 / 36

ABB i-bus

KNX
Start-up
SV/S xx.xxx.x.1 | 2CDC501049D0201 Rev. A 19
3 Start-up
This section describes the functions of the SV/S 30.640.5.1 and SV/S 30.320.2.1 KNX power supplies.
The devices are parameterized using the application program and Engineering Tool Software (ETS).
The application program can be found at ABB/System devices/Power Supplies.
For parameterization purposes, a PC or Laptop with ETS and a connection to the KNX, e.g. USB or
IP interface, is required.
Please note
While programming the SV/S, all indicators are off and the Reset button does not function. This is also
the case when the device is unloaded (ETS). However, the output voltage is generated irrespective of
the indicators.
3.1 Overview
The ABB i-bus
®
KNX SV/S 30.640.5.1 and SV/S 30.320.2.1 power supplies have extended features for
monitoring and diagnostics.
The table below gives an overview of functions, the values that can be queried, and the status messages
for the application program.
General SV/S 30.320.2.1 SV/S 30.640.5.1
In-operation function for device monitoring
■ ■
Request status/measured values
■ ■
Bus voltage U
N
■
■
Bus current I
1
■ ■
Current voltage output I
2
-
■
Total current I (= I
1
+ I
2
) -
■
Bus current I
1
or total current I > rated current I
n
■ ■
Overload I > I
max
■ ■
Trigger bus reset
■ ■