ABB | E-Hub 2.0
HOW TO SUPPLY POWER TO THE PRODUCT | Power Supply Specifications
41 | © 2019 ABB | DOC. N° 1SDH002109A1001 - ECN000125349 - Rev. A
HOW TO SUPPLY POWER TO THE PRODUCT
This product is not provided with any ON/OFF switch.
The Power IN connector is the disconnecting means from the power supply network.
1 - Power Supply Specifications
Power supply
Nominal: 12 or 24 VDC; Range: 9 to 30 VDC with transient protection
Power consumption
4 W typical; 15 W maximum
Peak demand
< 15 W
Power IN Connector
and Mating Connector
Specifications
The power input is protected against: surge, noise, reverse polarity, over-voltage.
NOTICE
The Power IN connector is NOT protected against short circuit.
Always include an external fuse to protect the product!
The E-Hub 2.0 provides the Power IN connector on the rear side.
Connector Layout:
Connector Pinout:
Pin # Signal
Type Description
1
Power IN +
P
Positive power supply input
2
Power IN -
P
Negative power supply input
3
NC
NC
Not Connected
Connector Specifications:
• Base strip, Header
• Gender: Male
• Type: 3-pin, 3.5 mm pitch
Mating Connector Specifications:
• Pluggable screw terminal block
• Gender: Female
• Type: 3-pin, 3.5 mm pitch
• Example:
• Manufacturer: Phoenix Contact
• Part Number: MC 1,5/ 3-STF-3,5 - 1847068
• (or equivalent)
