ABB | E-Hub 2.0
36 | © 2019 ABB | DOC. N° 1SDH002109A1001 - ECN000125349 - Rev. A
HOW TO INSTALL THE PRODUCT | How to Install the Product Using the Mounting Bracket
HOW TO INSTALL THE PRODUCT
The product is intended for professional use and must be installed by qualified personnel
only.
The product must be installed in a secured location, accessible to authorized personnel
only (for example in a cabinet / technical compartment).
By default, the E-Hub 2.0 comes with a DIN rail mounting clip fastened on the bottom side.
You can use this to install the E-Hub 2.0.
Optionally, you can replace the DIN Rail Mounting Clip with the Mounting bracket (optionally
available).
See also:
• “How to Install the Product Using the Mounting Bracket” below
• “How to Replace the Mounting Bracket with the DIN Rail Mounting Clip or Vice Versa” on
• “How to Install/Remove the Product on/from a DIN Rail” on page 40
1 - How to Install the Product Using the Mounting Bracket
To install the product in place, complete the following steps:
1. See “Mechanical Specifications” on page 34
2. Use the 4 slots available on the Mounting Bracket
3. Add all the necessary mounting hardware to safely fasten the E-Hub 2.0 in place according to
your installation requirements (for example use 4x M5 screws, with a minimum length of 15 mm).
Material, type, and length of the screws, and the maximum torque applicable, depend on
your installation requirements.
The Mounting Bracket is made of 2 mm aluminum alloy 6061 T6.
Fig. 14
