6
GAA610-M
ADVANCED EMISSION GAS MONITORING SYSTEM | OI/GAA610-M-EN REV. B
… 1 Safety
Intended use
The CEMcaptain GAA610-M analyzer system is designed for
continuous measurement of exhaust gases of marine diesel
engines. Measurement components are CO
2
and SO
2
which are
sampled downstream of the scrubber.
Any other use is not as specified. The specified use also includes
taking note of this operating instruction.
Improper use
The following are considered to be instances of especially
improper use of the device:
• For use as a climbing aid, for example for mounting
purposes.
• For use as a bracket for external loads, for example as a
support for piping, etc.
• Material application, for example by painting over the
housing, name plate or welding/soldering on parts.
• Material removal, for example by spot drilling the
housing.
The analyzer system must not be used to measure flammable
gases or combustible gas/air or gas/oxygen mixtures.
The analyzer system must not be installed in hazardous
locations.
Safety instructions
Requirements for safe operation
In order to operate in a safe and efficient manner the device
should be properly handled and stored, correctly installed and
set-up, properly operated and correctly maintained.
Personnel qualifications
Only persons familiar with the installation, set-up, operation and
maintenance of comparable devices and certified as being
capable of such work should work on the device.
Special information and precautions
These include:
• The content of this operating instruction,
• The safety information affixed to the device,
• The applicable safety precautions for installing and
operating electrical devices,
• Safety precautions for working with gases, acids,
condensates, etc.
National regulations
The regulations, standards and guidelines cited in this operator's
manual are applicable in the Federal Republic of Germany. The
applicable national regulations should be followed when the
device is used in other countries.
Safety of the equipment and safe operation
The device was built and tested in accordance with
EN 61010 Part 1 ‘Safety regulations for electrical measuring,
control and laboratory equipment’ and it left the factory in
perfect condition.
To maintain this condition and to assure safe operation, read
and follow the safety instructions in this operating instruction as
well as applicable type approval standards of classification
societies.
Failure to do so can put persons at risk and can lead to device
damage as well as damage to other systems and devices.
