ABB ACS800-17LC, Hardware Manual, Page: 70 / 182

Mechanical installation
64
Connecting the liquid pipes
1. Ensure the Axilock connectors are slid on pipe ends. See section Preparing the
liquid pipe connections on page 63 .
2. Position the liquid pipe ends against each other.
3. Centre the Axilock connector onto the pipe ends.
4. Tighten the connector bolts to a torque shown on the label attached to the
connector.
Connecting the PE busbars
Connect the PE busbars as shown below.
Parallel
misalignment:
max 3 mm (0.2”)
Angular error:
max 2° in any
direction
Axial gap: 5 to
15 mm (0.2” to
0.6”)
2
3
Tightening torque: 35–40 N·m (25–30 lbf·ft)
Strength class: 8.8
Spring washer
Plain washer
Plain washer
M10