ABB ACS480-04-09A8-1, Hardware Manual

Page: 229 / 240

Electrical installation
The BIO-01 module has removable spring clamp terminals. Use ferrules on the
multistranded conductor ends.
The connection diagram below is applicable to drives with the BIO-01 I/O extension
module when the ABB standard macro is selected (parameter
96.04 ).
1) Description Terminal
Connection
× Auxiliary voltage 24 V DC, max. 250 mA +24 V
OUT1
SGND
IN1
IN2
+24 V
DGND
DCOM
DI1
DI2
+24 V
DGND
DCOM
DI1
DI2
AI1
+10V
GND
SCR
DI3
DI4
DI5
DO1
× Auxiliary voltage output common DGND
× Digital input common for all DCOM
× Stop (0) / Start (1) DI1
× Forward (0) / Reverse (1) DI2
Constant frequency/speed selection S2 (DI3)
Constant frequency/speed selection DI4
Ramp set 1 (0) / Ramp set 2 (1) DI5
Not configured (DIO1) S1 (DO1)
Output frequency/speed ref: 0 … 10 V DC AI1
Reference v10 V DC (max. 10 mA) +10V
Analog circuit common / DO common GND
Signal cable shield SCR
× Safe torque off. Both IN1 and IN2 circuits must be
closed for the drive to start. (Factory connection.) SGND
× IN1
× IN2
× OUT1
1) × = on base unit, blank = on BIO-01 module.
Start-up
The BIO-01 module is automatically identified by the drive firmware. To configure the
inputs and outputs, refer to the drive firmware manual.
Technical data
Control connection data: Spring type terminal blocks. Conductor size accepted by
the terminals: 0.2 … 1.5 mm
2
(24 … 16 AWG). Exception: max. 0.75 mm
2
(18 AWG)
for a multistranded conductor with a ferrule and plastic sleeve.
BIO-01 I/O extension module 229