ABB ACS480-04-09A8-1, Hardware Manual

Page: 74 / 240

Connecting the control cables - IEC
Before you connect the control cables, make sure that all option modules are installed.
￭
Default I/O connection diagrams (ABB standard macro)
The connection diagrams below are applicable to the standard drive variant with the
RIIO-01 I/O & EIA-485 module. ABB standard macro (parameter
96.04 ) is used with
the default parameter settings.
2)
Description
Terminal
1)
Connection
Analog inputs and outputs
Signal cable shield (screen) SCR 1
SCR
AI1
AGND
+10 V
AI2
AGND
AO1
AO2
AGND
1…10 kohm
Max. 500 ohm
Output frequency : 0 … 10 V AI1 2
Analog input circuit common AGND 3
Reference voltage 10 V DC +10V 4
Not configured AI2 5
Analog input circuit common AGND 6
Output frequency : 0 … 20 mA AO1 7
Motor current : 0 … 20 mA AO2 8
Analog output circuit common AGND 9
Digital inputs and auxiliary voltage output
×
Aux. voltage 24 V DC, max. 250 mA
3) +24V 10
+24 V
DGND
DCOM
DI1
DI2
DI3
DI4
DI5
DI6
+24 V
DGND
DCOM
DI1
DI2
DI3
DI4
DI5
DI6
× Aux. voltage output common DGND 11
× Digital input common for all DCOM 12
× Stop (0) / Start (1) DI1 13
× Forward (0) / Reverse (1) DI2 14
Constant output frequency selection
4) DI3 15
Constant output frequency selection DI4 16
Ramp set 1 (0) / Ramp set 2 (1)
5) DI5 17
Not configured DI6 18
74 Electrical installation – IEC