Functions in the Options menu 51
4. Use
and
to move the cursor highlight.
•
To add a new parameter to an existing page,
highlight an area above, between or below
an existing parameter.
•
To edit or remove an existing parameter,
highlight that parameter.
5. Press
(
Edit
) to open the
Display Slot
menu.
6. Choose a parameter, its display settings and
scaling.
Note:
Parameters whose values have textual
representations (such as the names of bit
states) or contain characters other than
numbers (such as dates or durations) are
automatically displayed as text. For these parameters, Display style and
selections pertaining to numeric parameters are not available.
•
Parameter
: Select the parameter to show in the selected slot. The most
commonly used parameters are listed as presets.
For bit field parameters, you can select either a single bit or the full bit field to add
to the
Home
view. With individual bits, the bit state is displayed. Full bit fields are
shown in either hexadecimal or binary format.
Note:
If
Empty
is selected, the parameter is removed from the
Home
view.
•
Display style
: Select how the signal values are displayed. It is possible to use
different display types on the same page.
•
Numeric
: The parameter values are displayed as numbers (see figure 1
below). If there is only one parameter on the page, a bar graph is also
displayed.
•
Gauge/bar
: When there is one parameter on the page, the parameter value is
shown as a dial gauge (see picture 3 below). When there are two or three
parameters on the same page, the value is displayed as a bar graph (see the
slots in figure 2 below).
•
Graph
15 minutes, 30 minutes, 1 hour or 24 hours: The parameter value is
displayed as a graph within the selected time frame (see the bottom slot in
picture 2).
2
3
1
Summary of Contents for AC-AP Series
