A&D HV-15KCEP, Instruction Manual

Page: 9 / 48

HV/HW-CEP Series Page 7
4. Installing the Scale
4.1. Setting up the Scale
This procedure includes all of the steps for installing
the scale. Therefore, there may be some
unnecessary steps for some models.
Step 1 Take the base unit and pole out, taking care
not to pull on the load cell cable.
Step 2 Place the pan on the base unit. Remove the
protective film from the pan before use.
Step 3 Attach the pole to the bracket of the base
unit, while using care not to damage the load
cell cable.
Insert the remainder of the load cell cable
into the pole.
Affix the pole to the bracket using two hex
screws.
* With the HW-10KCEP and HV-15KCEP,
this procedure is not required because the
pole and bracket is a combined unit.
Step 4 Select a place for installing the scale. Refer
to "3.2. Precoution on Installing the Scale".
Step 5 Adjust the level of the base unit using the
bubble spirit level and the leveling feet.
Step 6 Adjust the angle of the display unit and fix by
display knobs.
Step 7 Check the weighing accuracy. If the scale
needs calibration, refer to "13. Calibration".
The display unit can be adjusted in five steps in the up-and-down direction. Setting
the display sideways is also possible. (Make sure that the pole is secured at the
lower part of the pole using the hex screws. Do not turn the display unit at a joint for
the pole.)
Bracket
Pole
Hex screws
3mm hex wrench
Step 3
Display unit
Display knobs
10°
30°
50°
70°
90°
Step 6
Ground
terminal
Pole
Load cell cable
Pan
Step 1
Base unit
Step 2
Leveling feet
Bubble spirit level
Step 5
OK NG