A&D HV-15KCEP, Instruction Manual

Page: 12 / 48

Page 10 HV/HW-CEP Series
5.2. Installing the Batteries
Step 1 Turn off the display.
Remove the right side display knob.
Tilt the Display unit to the front.
Step 2
Open the rear cover.
Step 3 Disconnect the power connector.
Step 4 Carry the battery box to
non-hazardous
areas.
Step 5 Using the hex wrench provided, remove the
battery box securing screws.
Step 6 Insert four new batteries with proper polarity
(+,-). Batteries are only the four “D”, “LR20”
or “AM1” alkaline 1.5 V batteries listed below
can be used.
DURACELL MN1300, ENERGIZER E95,
Panasonic LR20(XJ)
Step 7 Attach the battery cover and secure it using
the battery box securing screws.
Step 8 Close the covers in reverse order of step 3 to
step 1.
Caution
Replace used batteries with four new ones, when “
lb ” is displayed.
All 4 cells in single platform scale must be by the same manufacturer.
Do not mix used and new batteries. It may cause damage to the batteries or
the scale, if used.
Check the battery direction. If the batteries are installed in the wrong
direction, it may cause battery leakage. If the direction of a single battery is
wrong, the scale may work only temporarily.
Step 1
Display unit
Display knobs
Step 3
Step 2
Power connector
Battery box
Rear cover
Rear knobs
Step 4
Battery box
2.5mm hex wrench
Step 5