JANUARY 2010 - TD 220a DEPLOYMENT GUIDE, RDCP600
Page
21
Reliable solutions
As you progress with the steps, the completed
steps will turn
black
and a check mark will be
inserted next to it.
Tap
Go
to start the first step, perform the sub-
configuration and tap
Go
again until all steps are
completed and the button shows
Finished
.
Then tap
OK
in the top right corner to complete
the session.
Alternatively, the configuration can be set up for
each sub-section manually:
Tap the
Edit
button above the icons or the
icon.
Start with the
Site
section
and continue with
each section as laid out in the overview.
The setup program monitors your settings and
prevents you from picking illegible settings.
IMPORTANT! Perform the configuration steps
in the sequence laid out in the menu: Top to
bottom, left to right. This ensures that the system
has relevant information when it checks for
invalid configurations.
Figure 1-8 Wizard Alternate Configuration
The
Site
menu holds site-specific information about the
location
of the deployment. Check that
the
fixed parameters
are relevant for the location and enter other parameters as required. In the
installation page
, check the
instrument is looking downwards
if the deployment is a downward
installation, and choose the anticipated installation depth from the drop-down menu.
Make sure that the estimated installation depth and transducer direction are properly set at this
stage. The instrument will use this information later when calculating maximum ping rate etc.
Figure 1-7 Wizard Initial Steps
