Error! Use the Start tab to apply “Title 1” to the text need to be displayed here.
11
1.
The breakpoint re-start function is divided into 5 ways to search for the restarting point.
i.
Line number search: Search for the breakpoint based on the line number of the machining
program entered by the user.
ii.
Number search: The tool breakpoint search is performed according to the machining program N
number input by the user.
iii.
Breakline search: The breakpoint search is performed according to the breakpoint recorded by
the system.
iv.
M code search: The breakpoint search is performed according to the M code input by the user.
v.
T code search: The breakpoint search is performed according to the T code input by the user.
2.
After searching for the specified position, press the
start machining
to start the breakpoint position
recovery action, and the system will move to the top of the breakpoint.
3.
The height above the breakpoint is set by user parameter 8052.
4.
After moving to the top of the breakpoint, machining startup is pressed again, and the program
processing will start.
5.
Note
:
i.
Before using the breakpoint to restart, it must be confirmed that the machine has returned to the
origin, otherwise the function will not take effect (the set breakpoint cannot be found).
ii.
When restarting with a breakpoint, it's required to switch the operating mode to automatic
(MEM) mode.
File Management
3.3.
Function Path: Edit Group > File Management