Overview
May 2008 – Revision 1.3
Page 6 of 62
3M™ Wireless Communication System Model XT-1
Installation Manual
System Warnings
WARNING
To reduce the risks associated with hazardous voltage:
•
Disconnect power to the receptacle before installing or removing the
Base Station Power Supply. When removing receptacle cover screw,
cover may fall across plug pins or receptacle may become displaced.
Use only with duplex receptacle having center screw. Secure unit in
place by receptacle cover screw.
•
If power supply is supplied with a grounding pin, connect directly to a
grounding receptacle – 3 prong.
To reduce the risks associated fire & property damage:
•
Do not open, crush, expose to heat above 200
°
F or incinerate the
battery.
•
Always replace batteries, battery chargers and power supplies with
3M approved units acceptable for use in this system to avoid system
function & safety concerns.
•
Do not modify this 3M™ Wireless Communication System Model XT-
1. Install only 3M provided components. Use only 3M approved
system replacement parts.
CAUTION
To reduce the risks associated with environmental contamination due to
battery pack & to lead in the solder:
•
Dispose of batteries, power supplies, battery charger and base
station in accordance with federal, state & local requirements. If
preferred, return these components to 3M Service Center for
disposal.
Other Conventions
Important Notes and Notes
Important Note:
It is strongly recommended that you pay attention to information inside of an
“Important Note:” box.
Note:
You may find information inside of a “Note:” box helpful.
