Installation
3M™ Wireless Communication System Model XT-1
Installation Manual
May 2008 – Revision 1.3
Page 13 of 62
5.
Insert each battery to be charged into a slot on the charger. The charge
indicator lights for each slot will light steadily red to indicate that the
battery is charging or green to indicate that the battery is fully charged.
6.
When charging is complete, the batteries are ready for use.
Notes:
A fully discharged (dead) battery can take as long as 3 ½ hours to recharge.
Fully charged batteries should be stored whenever they are not in use.
Leaving them on the charger does not harm them or waste energy.
Install the Order Point Speaker and Microphone Assemblies
Use the recommended speaker and microphone systems listed below and follow
the included instructions:
•
3M™ Microphone Assembly. Part # 78-6911-4935-1
•
3M™ Speaker Assembly, Duplex, 5 inch. Part # 78-6911-4411-3
For information on wiring the speaker and microphone to the base station, see
“Base Station to Component Wiring,” page 19.
Install the Vehicle Detector(s)
Follow the instructions provided with the vehicle detectors for installing the
detector loop(s), speakers, and microphones.
For information on wiring and configuring the vehicle detector(s) to the base
station see “Base Station to Component Wiring,” page 19.
For information on installing the vehicle detector circuit boards in the base
station, see “Installing Accessory Boards in the Base Station” on page 25
Install the Base Station
Choose a Location
Generally, the base station should be located centrally, and close to the order
takers. However there are several important guidelines that must be followed to
reduce the risk of problems. Follow the guidelines to ensure that the base
station(s) can communicate with headsets in any foreseeable location:
•
Do not assume that the location of an old base station is suitable for a
new base station.
•
The LCD screen should be approximately 5 ft (1.5 m) from the floor.
•
The base station should be at least 3 ft (1 m) from large metallic
fixtures or appliances.
•
The base station should be within 6 ft (2 m) of a 110VAC, 15A or 20A
electrical outlet.
•
The base station would be away from inside corners, airborne grease,
and moisture.
•
Easily visible and the keypad accessible.
Pre-Testing the Location
Before you permanently mount the base station(s), one person can pre-test the
signal using the following procedure:
1.
Temporarily mount the base station where you think it may have good
range.
2.
Power the base station.
