3M W100, Manual

Page: 38 / 58

26
2011 October
WaterAct-M-S
8-MAINTENANCE AND REPAIRS
(continued)
8.25 Tape Channel Plate
To Remove:
1. Remove right side cover
(See Section 8-11).
2. Remove pinch roller
(See Section 8-19).
3. Remove weighted brush cover
(See Section 8-23).
4. Loosen dead roller and coder bar screws
(Figure 8-38).
5. Remove pinch roller spring stop
(Figure 8-38).
6. Remove two (2) screws attached to tape
channel plate.
7. Pull tape channel plate up allowing tape
channel plate and dead roller to rotate (making
screws underneath accessible -
Figure 8-39).
8. Remove two (2) screws connecting tape channel
plate and dead roller
(Figure 8-40).
New Part Installation:
1. With the left end of pinch roller spring on
top of screw and left side of the dispenser,
slide the pinch roller shaft into right side of
chassis.
Reverse the removal procedure above.
Note:
Insert shaft approximately 1/4 way in chassis.
8.26 Tape Basket / Motor Cover
To Remove:
1. Remove right side cover
(See Section 8-11).
2. Remove left side cover
(See Section 8-12).
3. Remove pinch roller
(See Section 8-19).
4. Remove weighted brush cover
(See Section 8-23).
5. Remove tape channel plate
(See Section 8-25).
6. Remove two (2) screws holding tape basket/
motor cover.
7. Remove tape basket/motor cover by lifting
straight up parallel with angle of tape basket/
motor cover
(Figure 8-41).
8. Remove-inspect-and/or install new tape basket
(Figure 8-42).
New Part Installation:
Reverse the removal procedure above.
Figure 11-19
Figure 8-38 Figure 8-39
Figure 8-37
Tape Channel
Plate
5
6
5
Figure 8-40
Figure 8-41