3M W100, Manual

Page: 41 / 58

29
2011 October
WaterAct-M-S
8-MAINTENANCE AND REPAIRS
(continued)
8.32 Gear Box / Motor Mount
To Remove:
1. Remove right side cover
(See Section 8.11).
2. Remove pinch roller
(See Section 8.19).
3. Remove weighted brush cover
(See Section 8.23).
4. Remove tape channel plate
(See Section 8.25).
5. Remove idler gear
(See Section 8.29).
6. Remove drive gear and clutch assembly
(See Section 8.30).
7. Remove set screw from feed wheel gear
(Figure 8-51).
8. Remove feed wheel gear
(Figure 8-51).
9. Remove bolts from gearbox/motor mount.
(Figure 8-52).
10. Remove gearbox/motor mount
.
New Part Installation:
Reverse the removal procedure above.
8.33 Ramp
To Remove:
1. Remove right side cover
(See Section 8.11).
2. Remove left side cover
(See Section 8.12).
3. Loosen screws on these parts: coder bar and
dead roller
-
weighted brush cover shaft
.
4. Remove four (4) screws holding ramp.
Remove the ramp
(Figure 8-53).
5. Attach four (4) screws to new ramp inside
locate thicker end of the ramp toward rear of
dispenser
(Figure 8-54).
6. Tighten loosened screws in #4 and reattach left
and right covers.
New Part Installation:
Reverse the removal procedure above.
Figure 8-51
Figure 8-52
Set
Screw
Feed
Wheel
Gear
Figure 8-53
Screw
Figure 8-54
Screws
•
To reduce the risk associated with
mechanical hazards:
−
Read, understand, and follow all safety and
operating instructions before operating or
servicing the tape dispenser.
−
Allow only properly trained and quali fi ed
personnel to operate and service this
equipment.
WARNING