3M W100, Manual

Page: 25 / 58

13
6-INSTALLATION
(continued)
2011 October
WaterAct-M-S
6.5 Leveling
Set the platform on a fl at surface which allows for even
weight distribution
(Figure 6-4)
.
Figure 6-4
•
To reduce the risk associated with
muscle strain:
− Use appropriate body mechanics when
lifting or repositioning this equipment.
WARNING
Mechanical Stop
Tape Guide
Turnbuckle
Top
Roller
Length Scale
Tape Guide
Top Cover
Pinch Roller
Pressure Plate
Figure 6-5
6.6 Loading Tape
(
Figures 6-5 and 6-6)
1. Open top cover of dispenser.
2. Using tape guide turnbuckle, adjust width of tape guides
to accommodate the tape.
3. Place tape roll in dispenser.
4. Using tape guide turnbuckle, re-adjust tape guides
leaving an 1/8” clearance on both sides of the tape.
5. Remove pressure plate from dispenser.
6. Feed tape (gummed side down) over top roller, under
tape
guide fl aps, and under pinch roller (
Figure 6-5).
Note:
For Tape that is "gummed side out" (typically used
in Europe), load tape roll opposite as shown while
routing with gummed side (over the top roller).
7. Place pressure plate over tape and release pinch roller.
The pressure plate must be loaded so it touches the
pinch roller shaft and the arrow on the pressure plate
points toward front of dispenser.
8. Close top cover.